 |
Face material:
108gsm ±10% Matte white photo paper
Glue:
Arylic permanent adhesive featuring high clarity and high cohesion,waterbased.
Liner:
60gsm ± 5% White glassine liner
| Tack Adhesion(FTM9) | 12N/25mm on stainless steel |
| Final Adhesion(FTM8) | >24h on stainless steel |
| Peel 20 min(FTM1) | 10N/25mm on stainless steel |
Weight (Glue) | 21±2gsm |
Thickness (Face paper) | 0.14mm ±10% |
| Brightness (face paper) | 90% |
| Labeling temp. min | Adhered to aluminum,after 48h/24℃,no variation |
Service temperature | Min.Appl.Temp: 10℃ Service Temp:–20 ~ 80℃ |
| Available Lengths&Widths | Custom sheet sizes available Roll width: 100mm - 1050mm |
Inkjet/Memjet printer for waterbased ink (for pigment and dye).
For best ink recommendations please contact your ink supplier.Teseting for suitability between media,printers and inks is always recommended prior to use.
We recommend to manitain an unprinted area of 3-4mm on the edges of the printed decal to avoid to avoid edge lifting
1 year stored at 50±10% RH at 20℃ in the original packing
Surfaces to which will be applied must be cleaned thoroughly of dust,grease or any contaminants.This information are based upon our knowledge and pratical experience but does not constitute a warranty.All information is subject to change without prior notice.
Face material:
108gsm ±10% Matte white photo paper
Glue:
Arylic permanent adhesive featuring high clarity and high cohesion,waterbased.
Liner:
60gsm ± 5% White glassine liner
| Tack Adhesion(FTM9) | 12N/25mm on stainless steel |
| Final Adhesion(FTM8) | >24h on stainless steel |
| Peel 20 min(FTM1) | 10N/25mm on stainless steel |
Weight (Glue) | 21±2gsm |
Thickness (Face paper) | 0.14mm ±10% |
| Brightness (face paper) | 90% |
| Labeling temp. min | Adhered to aluminum,after 48h/24℃,no variation |
Service temperature | Min.Appl.Temp: 10℃ Service Temp:–20 ~ 80℃ |
| Available Lengths&Widths | Custom sheet sizes available Roll width: 100mm - 1050mm |
Inkjet/Memjet printer for waterbased ink (for pigment and dye).
For best ink recommendations please contact your ink supplier.Teseting for suitability between media,printers and inks is always recommended prior to use.
We recommend to manitain an unprinted area of 3-4mm on the edges of the printed decal to avoid to avoid edge lifting
1 year stored at 50±10% RH at 20℃ in the original packing
Surfaces to which will be applied must be cleaned thoroughly of dust,grease or any contaminants.This information are based upon our knowledge and pratical experience but does not constitute a warranty.All information is subject to change without prior notice.
