 |
Face material:
100mic ± 10% Glossy white PP film
Glue:
Arylic permanent adhesive featuring high clarity and high cohesion,waterbased.
Liner:
80gsm ± 5% White glassine liner
| Tack Adhesion(FTM9) | 9N/25mm on stainless steel |
| Peel 20 min(FTM1) | 8N/25mm on stainless steel |
| Dimensional Stability | Adhered to steel,no shrinkage in cross ; in length ＜4% |
Heat Shrinkage Rate | Along:Max 5% Across:Max 3% |
Tensile Strength | Along:Min 50MPa Across:Min 100MPa |
| Elongation at Break | Along:Max 200% Across:Max 100% |
| Seawaterbility | Adhered to aluminum,after 48h/24℃,no variation |
Tremperature ranges | Min.Appl.Temp: 10℃ Service Temp:–20 ~ 80℃ |
| Available Lengths & Widths | Custom sheet sizes available Roll width: 100mm - 1050mm |
Inkjet/Memjet printer for waterbased ink (for pigment and dye).
For best ink recommendations please contact your ink supplier.Teseting for suitability between media,printers and inks is always recommended prior to use.
We recommend to manitain an unprinted area of 3-4mm on the edges of the printed decal to avoid to avoid edge lifting
1 year stored at 50±10% RH at 20℃ in the original packing
The application humidity range is 40% to 60%. Outside this humidity range, customers are advised to use it after testing.Surfaces to which will be applied must be cleaned thoroughly of dust,grease or any contaminants.This information are based upon our knowledge and pratical experience but does not constitute a warranty.All informationissubject to change without prior notice
Face material:
100mic ± 10% Glossy white PP film
Glue:
Arylic permanent adhesive featuring high clarity and high cohesion,waterbased.
Liner:
80gsm ± 5% White glassine liner
| Tack Adhesion(FTM9) | 9N/25mm on stainless steel |
| Peel 20 min(FTM1) | 8N/25mm on stainless steel |
| Dimensional Stability | Adhered to steel,no shrinkage in cross ; in length ＜4% |
Heat Shrinkage Rate | Along:Max 5% Across:Max 3% |
Tensile Strength | Along:Min 50MPa Across:Min 100MPa |
| Elongation at Break | Along:Max 200% Across:Max 100% |
| Seawaterbility | Adhered to aluminum,after 48h/24℃,no variation |
Tremperature ranges | Min.Appl.Temp: 10℃ Service Temp:–20 ~ 80℃ |
| Available Lengths & Widths | Custom sheet sizes available Roll width: 100mm - 1050mm |
Inkjet/Memjet printer for waterbased ink (for pigment and dye).
For best ink recommendations please contact your ink supplier.Teseting for suitability between media,printers and inks is always recommended prior to use.
We recommend to manitain an unprinted area of 3-4mm on the edges of the printed decal to avoid to avoid edge lifting
1 year stored at 50±10% RH at 20℃ in the original packing
The application humidity range is 40% to 60%. Outside this humidity range, customers are advised to use it after testing.Surfaces to which will be applied must be cleaned thoroughly of dust,grease or any contaminants.This information are based upon our knowledge and pratical experience but does not constitute a warranty.All informationissubject to change without prior notice
